• image
  • image
  • image
  • image
  • image
  • image
  • image
Previous Next

For most applications, a transimpedance (current-to-voltage) amplifier is recommended to allow the photodiode to operate in a virtually short circuit condition, thus retaining its linear response. Generally speaking, a photovoltaic (zero bias) circuit is used in applications where speed is not important. Biasing the photodiode (photoconductive operation) increases the speed, reduces junction capacitance and improves the linearity of the photodiode.


The feedback resistor must be chosen carefully because it will affect the output range and bandwidth of the circuit. Before choosing a resistor, the minimum/maximum light input signal, the number of decades of dynamic range desired, and the bandwidth all need to be considered. Following are formulas useful for designing a transimpedance amplifier circuit.


Output Voltage (Vout)






where IS =

 Photodiode light signal current


RF =

 Feedback Resistance
    R =  Responsivity at wavelength of irradiance, A/W
    PO =  Light power incident on photodiode active area, W


Feedback Capacitor (CF)


CF  = 0.5 π f RF where f  =  Maximum operating frequency, Hz
    RF =  Feedback resistance


Gain Bandwidth Product (GBP)


In order to maintain circuit stability at the frequency and gain chosen, an operational amplifier with a sufficiently high Gain Bandwidth Product must be chosen. This can be calculated using the formula:


GBP  = 2f²πRF(CF+CJ) where f =  Maximum operating frequency, Hz 
    RF =  Feedback resistance
    CF =  Feedback capacitance
    CJ =  Junction capacitance of the photodiode


PV and PC Circuits